champasebo.blogg.se

1. SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL HOW TO
2. SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL DRIVERS
3. SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL DRIVER

SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL DRIVER

VIA, JMicron JMB36X, Gigabyte GBB36X controllers: these controllers usually provide disk information but only with specific driver version.ITE controllers: these controllers usually provide disk information but only when non-RAID (ATA/ATAPI) firmware and driver set is used.It is recommended to connect both ends of the Y USB cable when using 2.5" USB drives to supply enough power to the disk. Older chips (and early production of USB 3.0 chips, manufactured before Feb 2010) do not have the required function, that's why no hard disk information is displayed. USB hard disks: most newer USB-ATA bridge chips used in USB hard disk enclosures supports the detection.Other RAID controllers may prevent detection of hard disk information or provides only limited information. The list of such RAID controllers available in the "RAID controllers" section at Hard Disk controllers. RAID arrays: most RAID controllers allow detection of hard disk status information when the hard disk drives are configured in RAID arrays.More information about Updating driver for AMD AHCI Compatible RAID Controller Please find updated driver from the Driver Zone page. AMD AHCI Compatible RAID controller: the driver of the current controller is old - and does not allow detection of hard disk status.

SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL DRIVERS

(these drivers usually support only minimal features but not detecting details). This problem is more frequent if the hard disk controller driver is supplied during Windows installation If possible, you may try a different version of Windows because of the different driver sets.

Updating the driver of the disk controller (if there is an updated version available) may help in this situation. The problem is related to the actual hardware (hard disk controller, external enclosure, port multiplier, etc.) or its driver which may block the detection.

SOFTRAID SHOWING JMICRON INSTEAD OF ACTUAL MODEL HOW TO

What is a weak sector? How to repair weak sectors?ĭo you have other questions? Browse the Q&A Knowledge Base or just let us know! How to repair hard disk drive? How to eliminate displayed hard disk problems? I believe TRIM is enabled (fsutil shows that), but Hard Disk Sentinel shows it is DISABLED. Why other software displays different health? Which is correct? Hard disk health is low or recently changed or I just installed a new (used) hard disk.

Do I need to worry or ask for replacement drive? I have bad sectors and my disk health is 90%. I encountered problem with Hard Disk Sentinel. I can't see the hard disk status on my drive icons. Is it possible to monitor disk status WITHOUT administrator rights? Is it possible to detect hard disk status of a remote computer? How Hard Disk Sentinel warns me if there is a problem? Why hard disk temperature is so important? Why no disk information detected for my RAID array? No hard disk temperature/health displayed.